Installation
Electrical Requirements
Gas Dryer
(120 Volt, 60 Hertz, with
NOTE: The wiring diagram is located behind the control panel, inside the control cabinet.
WARNING
To reduce the risk of fire, electric shock or personal injury, all wiring and grounding MUST conform with the latest edition of the National Electrical Code ANSI/NFPA 70 or the Canadian Electrical Code, CSA C22.1, and such local regulations as might apply. It is the customer’s responsibility to have the wiring and fuses checked by a qualified electrician to make sure the laundry room has adequate electrical power to operate the dryer.
W035
●The dryer is designed to be operated on a separate branch, polarized,
●The
WARNING
This dryer is equipped with a
W036
NOTE: A qualified electrician should check the polarity of the wall receptacles. If a voltage reading is measured other than that illustrated, the qualified electrician should correct the problem.
●DO NOT OPERATE OTHER APPLIANCES ON THE SAME CIRCUIT WHEN THIS APPLIANCE IS OPERATING. DO NOT OVERLOAD CIRCUITS!
●DO NOT operate both a washer and gas dryer on the same circuit. Use separately fused 15 Amp circuits.
WARNING
To reduce the risk of an electric shock or fire, DO NOT use an extension cord or an adapter to connect the dryer to the electrical power source.
W037
DO NOT OVERLOAD
CIRCUITS
DO NOT USE AN
ADAPTER
DO NOT USE AN
EXTENSION CORD
D009I
Figure 29
36 | © Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT | 801539 |