|
| Electrical Requirements | |
|
|
| |
If serial plate voltage is: |
| Tumbler can be converted to the following voltages: | |
|
| ||
100 Volt/60 Hertz/1 Phase INTERNATIONAL Models: | |||
1 Phase | 2W&G | ||
2W&G | 100 Volt/50 Hertz/1 Phase INTERNATIONAL Models: | ||
200 Volt/50 Hertz/ | 2W&G | ||
|
| ||
1 Phase | 1. | Prior to connecting electric service, locate transformer configuration jumper | |
2W&G |
| in junction box area. | |
2. | Remove the 208 Volt jumper and replace it with the 100 Volt jumper located | ||
(T30 Models Only) | |||
| in the literature packet from cylinder. | ||
|
| ||
| 3. | Remove small access cover from back of the fan motor. Locate the two | |
|
| internal jumper wires, brown and blue connected to motor terminals #6 and | |
|
| #2. Move brown wire from terminal #6 to terminal #2 and blue wire from | |
|
| terminal #2 to terminal #4. Be careful not to confuse light blue motor harness | |
|
| wire with the dark blue internal jumper. | |
| 4. | Carefully check motor wire connections with wiring diagram and verify that | |
|
| the motors are configured for low voltage operation before replacing covers. | |
| 5. | Repeat steps 1 through 4 for each upper and lower unit. | |
| 6. | Sign and date conversion sticker located on back of tumbler. | |
| 7. | Follow the instructions covered in Connecting Electrical Service section. | |
|
| ||
380 Volt/50 Hertz/ | |||
3 Phase | 3W&G | ||
3W&G | 1. | Prior to connecting electric service, locate transformer configuration jumper | |
(T30 Models Only) |
| in junction box area. | |
2. | Remove the 380 Volt jumper and replace it with the 415 Volt jumper located | ||
| |||
|
| in the literature packet from cylinder. | |
| 3. | Repeat steps 1 and 2 for each upper and lower unit. | |
| 4. | Sign and date conversion sticker located on back of tumbler. | |
| 5. | Follow the instructions covered in Connecting Electrical Service section. | |
|
|
| |
70304601 | © Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT | 39 |