Installation

Steam RequirementsSteam Heat Option Only

The optional steam connection is located at the upper right corner panel, as seen from the rear.

WARNING

Never touch internal or external steam pipes, connections, or components. These surfaces can be extremely hot and will cause severe burns. The steam must be turned off and the pipe, connections, and components allowed to cool before the pipe can be touched.

SW014

For washer-extractors equipped with optional steam heat, install piping in accordance with approved commercial steam practices. Steam requirements are shown in Table 9.

UW 2 Speed Pocket Hardmount

Steam Supply Information

Steam inlet connection, in. (mm)

1/2 (DN13) 12.7

 

 

Number of steam inlets

1

 

 

Recommended pressure, psi (bar)

30 – 80 (2.0 – 5.4)

 

 

Maximum pressure, psi (bar)

80 (5.4)

 

 

Table 9

 

NOTE: Failure to install the supplied steam filter may void the warranty.

30

© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT

F232085