Alliance Laundry Systems UW35B2 not

NOTE: If the washer-extractor is equipped with the WE-6 microcomputer, release the emergency stop button at this point in the procedure by pulling the button sharply.

4.Check the door interlock before starting operation:

a.Attempt to start the washer with the door open. The washer should not start with the door open.

b.Close the door without locking it and attempt to start the washer. The washer should not start with the door unlocked.

c.Close and lock the door and start a cycle. Attempt to open the door while the cycle is in progress. The door should not open.

If the door lock and interlock are not functioning properly, call a service technician.

5.Run a full test cycle:

a.For washer-extractors equipped with the WE-6 microcomputer, select Cycle 01 by pressing key 0 and key 1 on the keypad. Then press the Start key.

Run the complete cycle, checking operation of all functions.

Installation

b.For washer-extractors equipped with the S-series microcomputer, select an appropriate cycle from the 12 cycles listed in the S-series Operation/Programming manual F232087.

Run the complete cycle, checking operation of all functions.

As an alternative, a test cycle is available for the S-series microcomputer. To access the test cycle, verify that the RUN/PROGRAM mode toggle switch is in the RUN position. Press the Up or Down key until the display alternately flashes “CHEC” and “CYC,” indicating that the test cycle is selected. Press the Start key to begin the test cycle.

NOTE: Pressing the Start key while the test cycle is in progress will prompt the computer to advance to the next step in the test cycle. Drain steps may not be skipped.

c. For washer-extractors equipped with the mechanical timer, select any of the four cycles listed on the control module decal by pressing the corresponding button.

Run the complete cycle, checking operation of all functions.

6.Cylinder rotation must be clockwise in the extract step. If rotation is not clockwise in the extract step, disconnect power. A qualified electrician must reverse any two leads between the mains contactor and the motor.

F232085