x610 Series Layer 3 Gigabit Ethernet Switches Installation Guide
AC Power Connection to a Power Supply Module
To power on a switch with an AC Power Supply Module, perform the following procedure:
1.Position the power cord retaining clip in the up position, as shown in Figure 74.
100- |
|
240VAC | ~ |
|
Figure 74. Power Cord Retaining Clip in the Up Position
Note
The
2.Plug the power cord into the AC power connector on the rear panel of the unit, as shown in Figure 75. Lower the power cord retaining clip to secure the power cord to the unit.
Warning: Power cord is used as a disconnection device. To de- energize equipment, disconnect the power cord. E3
100- |
|
240VAC | ~ |
|
Figure 75. Connecting the AC Power Cord
107