Cabling an
Stacking Module
x610 Series Layer 3 Gigabit Ethernet Switches Installation Guide
1.Remove the plastic protector from the connector at one end of the stacking cable.
1244 |
Figure 63. Removing the Plastic Protector
2.Connect the cable to either Stack Port 1 or Stack Port 2 on the stacking module and secure by tightening the two captive thumbscrews.
3.Remove the plastic protector from the connector at the other end of the stacking cable and connect it to a Stack Port on the stacking module in the next switch of the stack. A stacking cable must crossover and connect to a different port on the next stacking module. Stack Port 1 on a module must connect to Stack Port 2 on the next module.
Caution
Do not connect two stack Port 1 ports or stack Port 2 ports together.
93