Allied Telesis X610-48TS/X, X610-48TS-POE+ manual Installing a VCStack Stacking Module, 4CPUCVR

Chapter 3: Installing the Hardware

Installing a

VCStack

Stacking Module

	DC PWR
AT-PWR1200	FAULT
	100-240VAC~ 16A MAX
	2267

Figure 46. AT-PWR1200 Power Supply

To install a power supply into a POE chassis, perform the following procedure:

1. Remove the module from the shipping package.

Note

Store the packaging material in a safe location. You must use the original shipping material if you need to return the unit to Allied Telesis.

2.Remove the blank panel from the power supply slot on the rear panel of the switch by loosening the two captive screws on the panel with a cross-head screwdriver, as shown in Figure 47.

Note

The x610-24Ts-POE+, x610-24Ts/X-POE+, x610-48Ts-POE+ and x610-48Ts/X-POE+ switch chassis are shipped from the factory with a blank panel installed in the rear panel power supply slot.

AT-
LX4	4CPUCVR
	UPPLY	WARNING			ave
		This	unit	may h			morene
		electric
	S			shock,
	POWER	unit.			discon
						RP		S I
				56V/18A		MAX
	2330

Figure 47. Removing the Blank Panel from the Power Supply Slot

82