Alloy Computer Products GSS-24T4SFP, GSS-16T4SFP user manual Ports, Enable Jumbo, Flow Control

GSS Series User Manual

3.2.2 Ports

The ports configuration page is used to display the current status of each port on the switch. In this section the user can also change the speed settings and flow control of each port and Jumbo Frame support can also be enabled from this location.

Fig. 3.3

Enable Jumbo

Frames: Tick the check box to enable Jumbo Frame support on each port.

Port:Is the physical port number of the switch.

Link Status: Displays the current link status of each port. Table below displays the values shown depending on connecting device:

Link Status	Description
1000FDX	Port is running at 1000M/Full Duplex
100FDX	Port is running at 100M/Full Duplex
100HDX	Port is running at 100M/Half Duplex
10FDX	Port is running at 10M/Full Duplex
10HDX	Port is running at 10M/Half Duplex
Down	No link is present

Link Mode: Used to disable Auto-Negotiation and force the speed and duplex settings of the port. Values are Auto Speed, 10 Half, 10 Full, 100 Half, 100 Full, 1000 Full and Disable. If disable is selected the port will be fully disabled and will not function. Fibre ports only have three options Auto Speed, 1000 Full and Disabled.

Flow Control: Used to enable Flow Control on the port.

Flow Control

Status: Displays the current flow control status.

Alloy Computer Products Pty Ltd Copyright ©2007

18