Antenna Receptacle
Power Antenna Lead (Blue)
Connect this lead to the +B terminal of your power antenna, if applicable.
Note
•This lead should be used only for controlling the vehicle’s power antenna. Do not use this lead to turn on an amplifier, or a signal processor, etc.
Remote
Connect this lead to the remote
Audio Interrupt In Lead (Pink/Black)
Connect this lead to the Audio interface output of a cellular phone which provides ground shorting when a call is received.
Illumination Lead (Orange)
This lead may be connected to the vehicle’s instrument cluster illumination lead. This will allow the backlighting of the
Switched Power Lead (Ignition) (Red)
Connect this lead to an open terminal on the vehicle’s fuse box or another unused power source which provides (+)12V only when the ignition is turned on or in the accessory position.
Battery Lead (Yellow)
Connect this lead to the positive (+) post of the vehicle’s battery.
Ground Lead (Black)
Connect this lead to a good chassis ground on the vehicle. Make sure the connection is made to bare metal and is securely fastened using the sheet metal screw provided.
Power Supply Connector
Right Front (+) Speaker Output Lead (Gray)
Right Front
Right Rear
Right Rear (+) Speaker Output Lead (Violet)
Left Rear (+) Speaker Output Lead (Green)
Left Rear
Left Front
Left Front (+) Speaker Output Lead (White)
Fuse Holder (10A)
Connect this to the output or input connector of other product (CD changer, IMPRINT audio processor, Equalizer, etc.) equipped with
Notes
•Interface adapter for iPod
•You can input TV/video sound by connecting an optional
•Be sure to set “Setting the Connected Head Unit (MODEL SETUP)” to “CD CHG”, when the
Steering Remote Control Interface Connector To steering Remote control interface box.
Rear Output/Input RCA Connectors
It can be used as Rear Output or Input RCA Connectors. RED is right and WHITE is left.
Front Output/Input RCA Connectors
It can be used as Front Output or Input RCA Connectors. RED is right and WHITE is left.
Subwoofer RCA Connectors RED is right and WHITE is left.
RCA Extension Cable (sold separately)
BLUETOOTH interface connector (Blue)
Connect this to an optional BLUETOOTH INTERFACE
Note
• Refer to “Setting the AUX+ Setup Mode” on page 22. AUX+ ON :
When the external device is connected. AUX+ OFF :
When set to OFF, AUX+ source cannot be selected.
System Switch
When connecting a processor or divider using
Notes
•Do not make the three switches to different settings.
•Be sure to turn the power off to the unit before changing the switch position.
USB Connector
Connect this to an USB Memory/Portable audio player or to an iPhone/iPod. To use an iPhone/iPod, Interface cable for iPod connection is required.
Notes
•Use the supplied USB cable. If a USB cable other than the supplied is used, correct performance cannot be guaranteed.
•Route the USB cable away from other cables.
To prevent external noise from entering the audio system.
•Locate the unit and route the leads at least 10 cm away from the car harness.
•Keep the battery power leads as far away from other leads as possible.
•Connect the ground lead securely to a bare metal spot (remove any paint, dirt or grease if necessary) of the car chassis.
•If you add an optional noise suppressor, connect it as far away from the unit as possible. Your Alpine dealer carries various noise suppressors, contact them for further information.
•Your Alpine dealer knows best about noise prevention measures so consult your dealer for further information.