Getting Started

Rotary encoder/ENTER/

(OPEN) /ESC

 

SOURCE/

SETUP

 

 

MUTE

 

 

Accessory List

 

 

•

Head unit ..................................................................................

1

•

Power cable...............................................................................

1

•

USB Cable..................................................................................

1

• Interface cable for iPod............................................................

1

•

Mounting sleeve.......................................................................

1

•

Carrying case ............................................................................

1

•

Bracket key ...............................................................................

2

• Screw (M5 × 8) ..........................................................................

4

•

Remote Control ........................................................................

1

•

Battery (AAA size).....................................................................

2

•

Owner’s Manual..................................................................

1 set

Turning Power On and Off

1Press SOURCEto turn on the unit.

Note

•The unit can be turned on by pressing any other button.

1Press and hold SOURCEfor at least 2 seconds to turn off the unit.

Note

•The first time power is turned on, the volume will start from level 12.

Source Selection

1Press SOURCEto change the source.

TUNER XM/SIRIUS*1 DISC USB*2/USB iPod*3 AUX+*4  Bluetooth Audio*5 CHANGER*6 TUNER

*1 Only when XM Radio or SIRIUS Radio is connected.

*2 Displayed only when no iPhone/iPod is connected.

*3 Displayed only when the iPhone/iPod is connected.

*4 Displayed only when the AUX+ SETUP is set to ON, refer to

“Setting the AUX+ Setup Mode” on page 22.

*5 Displayed only when Bluetooth IN is set to ADAPTER, refer to

“Setting the BLUETOOTH Connection” on page 21.

*6 Only when the CD changer is connected.

Detaching and Attaching the Front Panel

Detaching

1Turn off the unit power.
2Press (OPEN) to open the front panel (figure 1).

To close the front panel, press the left side until it locks as shown in the figure 2.

figure 1

figure 2

3Grasp the front panel firmly, slide to the left , and then pull to remove.

Notes

•The front panel may become hot in normal usage (especially the connector terminals on the back of the front panel). This is not a malfunction.

•To protect the front panel, place it in the supplied carrying case.

•When detaching the front panel, do not apply excessive force as it may result in malfunction.

•Do not leave the front panel open, or drive the car with the panel open as it may result in an accident or malfunction.

Attaching

1Insert the right side of the front panel into the main unit. Align the groove on the front panel with the projections on the main unit.

2Push the left side of the front panel until it locks firmly into the main unit.

Notes

•Before attaching the front panel, make sure that there is no dirt or dust on the connector terminals and no foreign object between the front panel and the main unit.

•Attach the front panel carefully, holding the sides of the front panel to avoid pushing buttons by mistake.

7-EN