Audio Setup
ENT.
RETURN
SETUP
Audio Setup Operation
•Audio Setup Operation is performed by the remote control unit.
The following 5 steps are common to each of the Audio Setup settings. Refer to the specific section for details.
1Press SETUP before inserting a disc, or when in stop mode.
The setup menu appears on the monitor.
S E T U P
L A | N G U A G E S |
|
|
T V S C R E E N | 1 6 | 9 W I D E | |
P A R E N T A L | O F F | E N | |
A U D I O S E T U P |
|
| |
C U S T O M S E T U P |
|
| |
2Press 
or 
to select “AUDIO SETUP,” then press ENT.
3Press 
or 
to select your desired setting item, then press ENT.
AUDIO SETUP items:
DIGITAL OUT/ DOWNMIX MODE
S E T UP
A U D I O S E T U P
D I G I T A L O U T
D O W N M I X M O D E S U R R O U N D
5When the setting is complete, press SETUP.
The setup returns to normal mode.
•When settings are changed, old settings are overwritten. Make a note of the current settings before making changes. If the vehicle’s battery is disconnected, the settings will be cleared and will return to the factory settings.
Setting the Digital Output
Use the following procedure to set the digital audio signal output from the
Setting item: DIGITAL OUT
Further setting items: DOLBY D / DTS
Press 
or 
to select your desired setting item, then press
ENT.
DOLBY D: Sets Dolby Digital output.
The initial setting is BITSTREAM.
DTS: Sets DTS output.
The initial setting is BITSTREAM.
Setting contents: BITSTREAM / LPCM
Press 
or 
to select BITSTREAM or LPCM, then press
ENT.
BITSTREAM:The digital output is switched automatically according to the type of audio signal being played.
Be sure to select “BITSTREAM” when you want to connect a digital audio processor and play Dolby Digital audio. “BITSTREAM” is selected upon shipment from the factory.
LPCM: The audio signal recorded on the disc is converted to 48 kHz/16 bit (for DVDs) or 44.1 kHz (for video CDs and CDs) linear PCM audio signals for output.
•Press RETURN to return to the previous screen.
or 
to change the setting, then press ENT.