Error displays
•Mechanical error
-Press 
. After the error indication disappears, insert the disc again. If the
problem, consult your nearest Alpine dealer.
MP3 is not played back.
•Writing error occurred. The CD format is not compatible.
-Make sure the CD has been written in a supported format. Refer to “About MP3/WMA” on pages
Playback does not start.
•Disc is loaded
-Check the disc and load it with the labeled side facing upward.
•Disc is dirty.
-Clean the disc.
•A disc not able to playback with this unit is loaded.
-Check if the disc is able to be played back.
•Parental lock is set.
-Cancel the parental lock or change the rating level.
Image stops sometimes.
•Disc is scratched.
- Replace with a
Audio
The sound is not output from the speakers.
•Unit has no output signal of the internal amplifier. - POWER IC is switched to “ON” (page 26).
Indication for CD Player
•Protective circuit is activated due to high temperature.
-The indicator will disappear when the temperature returns to within operation range.
•No CD is inserted.
-Insert a CD.
•Although a disc is inserted, “NO DISC” is displayed and the unit does not start to play or eject the disc.
-Remove the disc by following these steps:
Press the 
button again for at least 2 seconds.
If the disc still does not eject, consult your Alpine dealer.
•Mechanism error.
1)Press the 
button and eject the CD.
If not ejecting, consult your Alpine dealer.
2)When the error indication remains after ejecting, press the 
button again.
If the error indication still does not turn off after pressing the 
button for a few times, consult your Alpine dealer.
•When “ERROR” is displayed:
If that the disc cannot be ejected by pressing 
, press the RESET
switch (refer to page 9) and press 
again.
If the disc still cannot be ejected, consult your Alpine dealer.
•A
- You can only play back
•The disc is not written in a MP3/WMA supported format. - Use a disc written at the MP3/WMA supported format.
