Getting Started
OPEN/CLOSE | TILT , | Action indicator |
FLAT/SLIDE MUTE
SOURCE/POWER
Rotary encoder | WIDE/DISP. |
Basic Operation
This section describes the basic operation of the DVD. These operations also apply to the other sources.
1 Press SOURCE/POWER on the unit to turn the power on.
3 Press SOURCE/POWER.
The display shows the main menu screen.
4 Turn the Rotary encoder and select "DVD PLAYER" from the main menu.
•If an optional DVD player or DVD Changer is connected and its power is on, the display shows " EXT.DVD or DVD CHG
, AUX2 " instead of " AUX1
AUX2 ."
•If both the optional DVD player and DVD Changer are connected, the display shows " EXT.DVD " instead of " AUX1 ", and " DVD CHG " instead of " AUX2 ".
5 Press the Rotary encoder to execute the selection.
The DVD player mode screen is displayed. (The DVD disc is played back.)
•If PAGE 1/2 or PAGE 1/3 appears in the Function Guide
menu, there are additional functions available for the selected source. Access these functions by pressing 7.
6 Press SOURCE/POWER again to select another source.
Tip
The action indicator always lights up except for the following cases.
•Blinks when the monitor opens or closes.
•Blinks when the answer phone has a message. (Only when Mobile Hub
•Does not light up when the Illumination Control (Dimmer) is set to ON.
2 Press OPEN/CLOSE to open the monitor.
The unit beeps 3 times and raises the monitor. The opening screen appears on the monitor.
DVD Mode Screen
Selected Source |
|
|
| Current Time |
|
|
Shows the audio disc or video disc currently playing
(During MP3 playback, shows the sampling rate and the bit rate of the MP3 file when it was made.)
*Working State indicator
Volume Level 
The Function Guide displays the labels for each of the Function buttons. These labels will change depending upon the functions for the selected source.
*Tip
1Press and hold WIDE/DISP. for more than 2 seconds. The working indicator display in the mode main screen is switched to the spectrum analyzer display.
2Press and hold again WIDE/DISP. for more than 2 seconds to return to the working indicator display.
