Installation
Installing the Monitor
Installation Location
Reinforce the monitor unit with a metal mounting strap (not supplied). Secure the ground lead of the unit to a clean metal spot using a screw (}) already attached to the vehicle's chassis.
•For the screw marked }}, use an appropriate screw for the chosen mounting location.
Before deciding on the mounting location, check that opening and closing the display will not hamper gear shifting in that position.
3
•Install at an angle of within 30 degrees from the horizontal.
1
Dashboard | Mounting Bracket |
| (Included) |
Connect each input lead coming from an amplifier or equalizer to the corresponding output lead coming from the left rear of the
Mounting Sleeve | Lock Pin |
(Included) |
|
Slide the | |
| place, make sure the locking pins are fully seated in the |
| down position. This can be done by pressing firmly in on |
| the unit while pushing the locking pin down with a small |
| screwdriver. This ensures that the unit is properly locked |
Screws (M4 x 3) | and will not accidentally come out from the dashboard. |
(Included) | Install the supplied Front Frame. |
Slide the mounting sleeve into the dashboard. Install the supplied bracket on the monitor.
•Make sure to use the supplied screw (M4 x 3) to install the monitor.
If you use another screw to install the monitor, it may cause a malfunction.
2
Screw
Hex Nut (M5)
Bolt Stud
Metal Mounting
Strap
Ground
Lead
Chassis | Front Frame |
(Included) |
Wider edge should face down.
Removal
1.Use a small screwdriver (or similar tool) to push the locking pins to the "up" position (see Step 3). As each pin is unlocked, gently pull out on the unit to make sure it does not
2.Pull the unit out, keeping it unlocked as you do so.
<JAPANESE CAR >
To install using the vehicle's standard bracket.
| Screws (M4 x 3) |
Ground Lead | (Included) |
| |
| |
| Mounting Bracket |
•Make sure to use the supplied screw (M4 x 3) to install the monitor.
If you use another screw to install the monitor, it may cause a malfunction.