Alpine IVA-D900 owner manual Hi-Temp, No Disc, Indication for CD/MP3, 63-EN

Error displays

•Mechanical error

-Press c. After the error indication disappears, insert the disc again. If the above-mentioned solution does not solve the problem, consult your nearest ALPINE dealer.

MP3 is not played back.

•Writing error occurred. The CD format is not compatible.

-Make sure the CD has been written in a supported format. Refer to "About MP3" (pages 13 and 14), then rewrite in the format supported by this device.

Unit does operate.

•Monitor’s power is not turned on.

-Turn on the monitor’s power.

•Condensation.

-Wait a while (about 1 hour) for the condensation to dry.

No picture is produced.

•Monitor’s mode is not switched to the mode you want to see.

-Switch to the mode you want to see.

•Monitor’s parking brake lead is not connected.

-Connect the monitor’s parking brake lead and set the parking brake.

(For details, refer to the monitor’s instructions.)

•Monitor’s parking brake is not set.

-Connect the monitor’s parking brake lead and set the parking brake.

(For details, refer to the monitor’s instructions.)

Playback does not start.

•Disc is loaded upside-down.

-Check the disc and load it with the labeled side facing upward.

•Disc is dirty.

-Clean the disc.

•A disc not able to playback with this unit is loaded.

-Check if the disc is able to be played back.

•Parental lock is set.

-Cancel the parental lock or change the rating level.

Picture is unclear or noisy.

•Disc is being fast-forwarded or fast-reversed.

-The picture may be slightly disturbed, but this is normal.

•Vehicle’s battery power is weak.

-Check the battery power and wiring.

(The unit may malfunction if the battery power is under 11 volts with a load applied.)

•Monitor’s fluorescent tube is worn.

-Replace the monitor’s fluorescent tube.

Image stops sometimes.

•Disc is scratched.

- Replaced with a non-scratched disc.

Indication for CD/MP3

HI-TEMP

•Protective circuit is activated due to high temperature.

-The indicator will disappear when the temperature returns to within operation range.

-Leave the power OFF until the temperature decreases and then turn the power ON again.

NO DISC

•No disc is inserted.

-Insert a disc.

•Although a disc is inserted, “NO DISC” is displayed and the unit does not start to play or eject the disc.

-Remove the disc by following these steps: Press c for at least 3 seconds.

Continued

63-EN