lWhen replacing the projector lamp module:
oPut the projector into Standby mode and wait 30 minutes for the lamp to cool
completely.
oDo not remove any screws other than those specified in the lamp replacement
instructions.
oWear protective eyewear while changing the lamp module. Failure to do so can cause
injuries including loss of eyesight if the lamp shatters or bursts.
oUse only replacement lamp modules approved by SMARTTechnologies. Contact your
authorized SMART reseller for replacement parts.
oNever replace the lamp module with a previously used lamp module.
oAlways handle the fragile lamp assembly with care to prevent premature lamp failure or
exposure to mercury. Use gloves when touching the lamp module. Do not touch the
lamp with your fingers.
oRecycle or dispose of the lamp module as hazardous waste in accordance with local
regulations.
You need a Phillips No. 2 screwdriver and a flat screwdriver to complete these procedures.
gTo remove the old lamp module
1. Press the Power button on the ACP and select the Standby button to put the projector into
Standby mode.
OR
Press the Power button twice on the remote control to put the projector into Standby mode.
2. Wait at least 30 minutes for the projector to cool down.
3. Disconnect the power cable from the projector.
C H A P T E R 6
Maintaining your interactive whiteboard system
52