I M P OR T A N T
When entering commands, ensure there is a 10 millisecond delay between characters for reliable
operation.
N O T E S
lSend a command only after the projector sends a command prompt.
lCommands aren’t case sensitive. Type commands exactly as they appear in the left column
of the tables, with the proper value or setting in the center column.
lCheck your entries carefully before entering your commands.
lPress ENTER after typing each command.
lAfter the projector executes a command, it generates a response.
lTo prevent buffer overrun, don’t send another command until you receive the next command
prompt.
Value-based command methods
Absolute values and adjustment values
You can use the command’s target range to set an absolute value for a command or cause an
adjustment to be made to the current value. To create an adjustment command, add a plus (+) or
minus (-) symbol instead of the equal symbol (=) before the value change you want to enter.
All absolute values you enter must be within the command target range, and all adjustment values
must equal a number within the command target range.
See the following examples for adjusting projector brightness:
>get brightness
brightness=55
>set brightness=65
brightness=65
>set brightness+5
brightness=70
A P P E N D I X B
Remotely managing your system through an RS-232 serial interface
86