BAR, mBar, Atm, Kgf plus torr, inches and mm of mercury or water at a variety of temperatures. Characterized modules for laboratory accuracy in the shop, control room or field.

Voltage Calibration

Calibrate all your DC millivolt and voltage instrumentation. Source from 0.00 to 110.00 mV and 0.00 to 10.25 V. Read up to 110.00 mV, 11.00 V and 200.0 VDC.

Temperature Calibration

Source and Read directly in °C and °F for T/C types J, K, T, E, R, S & N and four Pt 100 Ohm, Ni 120 Ohm and Cu 10 Ohm RTDs. Resolution to 0.1°. Cold junction compensation tracks ambient temperature changes.

Frequency Calibration

Generate zero crossing square waves from 1 to 1000 Hz,

0.01to 10.00 kHz and from 1 to 1000 CPM (Counts-Per- Minute). Built-in frequency counter measures Hz, kHz & CPM.

Measure AC Voltage

Check line voltage or mains from 0.0 to 250.0 volts AC. Great for troubleshooting power problems.

Check Continuity

Locate pairs of wires, open connections and shorts with

Rear Label - Condensed Operation Guide

GENERAL

TURN-ON

Each time you turn on the TechChek 830-KP it runs through a self check then returns to the most recently selected settings.

SOURCE - The three QUIK-CHEK outputs will be the same as previously stored. Each time a different function is selected, the associated three QUIK-CHEK outputs will be recalled.

READ - The 830-KP is ready to measure the same signal as the last time it was used and automatically updates the MAX & MIN readings for recall at any time.

CONNECTIONS

TechChek 830-KP has protected banana jacks compatible with standard and safety banana plugs.

Included with your TechChek are: a pair of safety test leads with test probes, safety alligator clips, standard alligator clips and spade lugs for attachment to a wide variety of instruments. An additional test lead and spade lug are also included for 3-Wire RTD connections.

A second pair of test leads with right angled safety banana plugs and alligator clips for mA Read and Power Transmitter functions. Thermocouple connections are made through a miniature thermocouple socket.

Optional KIT-1 includes T/C wires for Type J, T, E & K with miniature T/C plugs (not included).

!

!

!

!

 

 

CAUTION! To prevent accidently overloading the instrument being tested, correctly set up the outputs before connecting the TechChek 830-KP to any instruments to be calibrated.

2

3

Page 3
Image 3
Altek 830-KP manual Rear Label Condensed Operation Guide, General TURN-ON, Connections