Process Calibrator | Altek 830-KP instruction

Process Calibrator

TechChek™ 830-KP

Image 1

Altek 830-KP manual Process Calibrator

Contents

Process Calibrator General Information Contents General TURN-ON Rear Label Condensed Operation GuideConnections Operating Instructions General Display Contrast PowerDisplay Backlighting Turn OFF Storing QUIK-CHEK Outputs Source ModeRecalling QUIK-CHEK Outputs Calibrate Milliamp Inputs Wire mA, 2-WIRE % Percent of 4 to 20 mA 2-WIRE DP % Simulate 2-WIRE TransmittersCalibrate Voltage Inputs Check 1-5 Volt Inputs Without Disconnecting Wires Calibrate Resistance Inputs Calibrate Thermocouple Inputs Three Wire RTD Connection Two Wire RTD ConnectionFour Wire RTD Connection Calibrate RTD Inputs Calibrate Frequency Inputs OUT of Range SignalsRead Functions MIN/MAX Read DC and AC Voltage Outputs MV, V, Vhi and Vac Read Milliamp OutputsConnection for DC Volts to 200.0 vhi Measure Thermocouple Sensors Read AC Voltages Ohms Read ResistanceCheck Continuity Measure RTD Sensors Black Count Frequencies Connection for signals with amplitudes to 250 V RMS Calibrate 4-WIRE Transmitters Calibrate 2-WIRE TransmittersCalibrate Transmitters ANY Source Function Read mA, Read %, Read DP% Read Presssure Fitting InstallationRead Pressure Calibrate Pressure Transmitters Read Pressure Specifications Cold Junction Accuracy ±1C Measure DC Volts RangesRead Thermocouples Read Ohms Type Range Accuracy Thermocouple Specifications RTD Type Alpha Range Accuracy RTD Specifications Ordering Information Warranty PN 1800470 Rev a April