MULTITASKER™
32) | [ + ] | Increment volume |
33) | [ - ] | Decrement volume |
34) | [RUP] | Ramp UP to max (32) |
35) | [RDN] | Ramp DOWN to mon (0) |
36) | [RUPm] | Ramp volume UP to max (32) |
37) | [RUPm=] | Ramp volume UP to a value |
38) | [RDNm] | Ramp volume DOWN to min (1) |
39) | [RDNm=] | Ramp volume DOWN to a value |
40) | [RST] | Stop ramping |
41) | [RAMP] | Display ramp rate |
42) | [RAMP=] | Set ramp rate |
43) | [MUT0] | Output Volume ON |
44) | [MUT1] | Output Volume OFF |
45) | [MAT] | Matrix Configuration |
46) | [HELP] | Display available commands |
TROUBLESHOOTING GUIDE | 8 |
We have carefully tested and have found no problems in the supplied
8.1 LED IS NOT LIT
Cause 1: Card cage is not plugged in.
Solution: Plug card cage in. If the LED lights, the problem is solved. If the LED is still not ON, see Cause 2.
Cause 2: Card is not plugged in all the way.
Solution: Push the card in all the way. If the LED is still not ON, see Cause 3.
Cause 3: Card cage slot has a problem.
Solution 1: Test the card in other slots of the card cage. If the slot was damaged, the card may work in other slots. If other slots work and the LED lights, the problem is the card cage slot. The card cage may require service. Call ALTINEX at (714)
Solution 2: Take any other known good card with an LED and verify that the slot used is good by seeing if the other card’s LED lights in that slot. If it lights, then the original card may be the source of the problem. Call ALTINEX at (714)
8.2 LED IS BLINKING RED
Cause 1: The CPU on the card is not working properly.
Solution 1: Look at the card and verify that there is no damage. If there is no damage, see Solution 2.
Solution 2: Verify that all IC’s are seated in their sockets. If the LED is still blinking red, see Cause 2.
23 |
