Alto-Shaam AR-7E Cau Tio N, Serv Ic E, Bee N Compl Ete D, Bu Lb Repl Ac Em En T In Struct, Ions

SERV IC E

DA NGE R

LOC K- OU T OR PO ST

BREAKE R PANE L UNTIL

SERV IC E WOR K HAS

BEE N COMPL ETE D.

CAUTION

THIS SECTION IS PROVIDED FORTHE ASSISTANCE OF QUALIFIED SERVICETECHNICIANS ONLYAND IS NOT INTENDED FOR USE BY UNTRAINED OR UNAUTHORIZED SERVICE PERSONNEL.

DA NG ER

DISCO NNECT UNI T FROM

POWER SOUR CE BEFORE

CLEANING OR SERV ICING .

DA NG ER

ELECTRICAL CONNECTIONS MUST

BE MADE BY A QUALIFIED SERVICE

TECHNICIAN IN ACCORDANCE WITH

APPLICABLE ELECTRICAL CODES.

BU LB REPL AC EM EN T IN STRUCT		IONS
	A	To Replace Bul bs:
		A Remove four screws holding glass lig ht cover
			(CV-26607) and gasket (GS- 26609) in plac e, tak ing
			care to not let the glas s cover (GL-26608) fall into
			the oven.
		B	Pull bulb out
		C Push replacement bulb (LP-34213) in place
		D	Re-insta ll glass cover and gasket, securin g with four
			scre ws removed in step one.

B & C

D

CAU TIO N

DO NOT HANDLE NEW BULB WITH

BARE HANDS. WHITE COTTON

GLOVES SHOULD BE WORN WHEN

REPLACING BULBS.

CAU TIO N

The performance of this unit has been optimized using the factory provided bulbs. These bulbs should be replaced with an exact replacement or with a factory recommended replacement. These bulbs have been treated to resist breakage and must be replaced with similarly treated bulbs in order to maintain compliance with NSF standards. DO NOT over-tighten bulbs in their receptacles as this can cause damage to the bulb filament.

Part numbers and drawings are subject to change without notice.

AR -7E Roti ss er ie Oper at ion & Care Manual • 22