Amana 8113P515-60 Cooktop, Burner Grates, Sealed Burners, High Performance Burner, Simmer Burner

Surface Cooking

Cooktop

To prevent the cooktop from discoloring or staining:

•Clean cooktop after each use.

•Wipe acidic or sugary spills as soon as the cooktop has

cooled as these spills may discolor the porcelain.

Unlike a range with standard gas burners, this cooktop does not lift-up nor is it

removable. Do not attempt to lift the cooktop for any reason.

Burner Grates

The grates must be properly positioned before cooking. Improper installation of the grates may result in chipping of the cooktop.

Do not operate the burners without a pan on the grate.

The grate’s porcelain finish may chip without a pan to absorb the heat from the burner flame.

Although the burner grates are durable, they will gradually lose their shine and/or discolor, due to the high temperatures of the gas flame.

Sealed Burners

The sealed burners of your range are secured to the cooktop and are not designed to be removed. Since the burners are sealed into the cooktop, boilovers or spills will not seep underneath the cooktop.

However, the burner should be cleaned after each use. (See page 21 for cleaning directions.)

High Performance Burner

(12,000 BTU*)

There is one high speed burner on your range, located in the right front position. This burner offers higher speed cooking that can be used to quickly bring water to a boil and for large- quantity cooking.

Simmer Burner

This burner is located in the left rear position. The simmer burner offers a lower BTU* flame for delicate sauces or melting chocolate.

* BTU ratings will vary when using LP gas.

Notes:

•A properly adjusted burner with clean ports will light within a few seconds. If using natural gas, the flame will be blue with a deeper blue inner cone.

If the burner flame is yellow or is noisy, the air/gas mixture may be incorrect. Contact a service technician to adjust. (Adjustments are not covered by the war- ranty.)

With LP gas, slight yellow tips on the flames are acceptable. This is normal and adjustment is not necessary.

•With some types of gas, you may hear a “popping” sound when the surface burner is turned off. This is a normal operating sound of the burner.

•If the control knob is turned very quickly from High to Low, the flame may go out, particularly if the burner is cold. If this occurs, turn the knob to the OFF position, wait several seconds and relight the burner.

•The flame should be adjusted so it does not extend beyond the edge of the pan.

6