Installation Instructions
8.Remove (4) 1/4" screws with a magnetic extended screw driver.
9.Pull air grille assembly forward.
Air grille assembly
1/4" screws
10.Verify operation by plugging in power cord. Power switch will be shipped in the on position and the showroom switch will be shipped in the off position. Display should flash. Press any key. There is a 6 minute delay before refrigerator starts. Verify position of each switch if there is no power to refrigerator.
Showroom 
switch
Power
switch
11.Pull end of nylon cord around refrigerator side (side without 1/4" panel installed, if any) level with top of refrigerator door. Tape cord in place.
12.Roll refrigerator into cutout to within 3" of being flush with kitchen cabinets. To avoid kitchen cabinet damage, place cardboard between kitchen cabinets and refrigerator. Push cardboard back with refrigerator and remove cardboard when refrigerator is in place. Remove power cord slack by pulling nylon cord straight out while pushing refrigerator completely into place. Power and nylon cord will rest along refrigerator side.
Pull nylon cord straight out
Power cord must rest as shown
13.Level refrigerator by turning front and rear leveling wheel bolts clockwise to raise refrigerator and counterclockwise to lower refrigerator. Rotate stabilizing legs until firmly in place against floor.
14.Align refrigerator with sides of kitchen cabinets using leveling bolts.
15.Secure lag bolts by removing center air grille blade. Screw lag bolts securely into 2x4 mounting board using a magnetic 6" extension socket. See "Installation Specifications".
Lag bolts
WARNING
To avoid electrical shock which can cause severe personal injury or death, disconnect power to refrigerator using power switch before performing any installation procedure. After performing installation procedure, connect power using power switch.
16.Push extra nylon cord back in along side of refrigerator out of sight or cord can be flush with refrigerator.
RS1200001 | 6 | November 1996 |
