AMD N2PAP-LITE Headers, Primary IDE Connector 40-pin block IDE1, Line-Out, MIC Header 9-pin Audio

(9)Primary IDE Connector (40-pin block): IDE1

This connector is for IDE hard disk ribbon cable connection. Connect the single plug end to motherboard and the two plugs at other end to your hard disk(s). If you install two hard disks, you must configure the second drive to Slave mode by setting its jumpers accordingly. Please refer to the documentation of your hard disk for the jumper settings.

(10)Secondary IDE Connector (40-pin block): IDE2

This connector connects to the another set of Master and Slave hard disks. Follow the same procedure described for the primary IDE connector. You may also configure two hard disks to be both Masters using one ribbon cable on the primary IDE connector and another ribbon cable on the secondary IDE connector.

IDE2

IDE1

Pin 1 Pin 1

•Two hard disks can be connected to any one of the connectors. The first HDD is referred to as the “Master” and the second HDD is referred to as the “Slave”.

•For best performance, we strongly suggest do not install CD-ROM or DVD-ROM drive on the same IDE channel as a hard disk. Otherwise, the system performance on this channel may drop.

2-6-2 Headers

(1)Line-Out, MIC Header (9-pin): AUDIO

This header connects to front panel line-out, MIC connector with cable.

GND VCC	R	L
	RET	RET
_		_
_ _ _		_
AUD AUD	AUD	AUD

AUDIO 2

Pin 1

10

9

	BIAS	R		_
					L
_	_				FPOUT
	MIC FPOUT
MIC	_		ON
AUD		_
	AUD AUD		HP AUD
	_ _			_
Line-Out, MIC Headers

14