Chapter 2
Hardware Installation
2-1 Hardware installation Steps
When installing the system, make sure to follow steps described in below:
1.Check motherboard setting
2.Install CPU
3.Install memory
4.Install expansion cards
5.Connect ribbon cables, panel wires, and power supply
6.Setup BIOS
7.Install software driver & utility
2-2 Checking Motherboard’s Jumper Setting
(1)Keyboard Power On function Enabled/Disabled: JP1
USB
When set as Enabled you can use keyboard to power on the system by password key- in, and use USB device to wake up the system.
JP1
3 JP4
1
JP1
3 JP4
1
1
1
| JP1 | K/B Power On Disabled (Default) | |
3 | JP4 | USB Power On Disabled (Default) |
|
| JP1 | K/B Power On Enabled | |
| ||||
3 |
| JP4 | USB Power On Enabled |
(2)CPU Front Side Bus Frequency Setting (2-pin) : JP2
1 2
JP2
1 2
JP2
ON : (AUTO) OFF : 100MHz
CPU Front Side Bus Frequency
6