AMD N2PAP-LITE, N2PA-LITE user manual IRQ Resources, Resource Controlled By, PCI/VGA Palette Snoop

Normally, this field is set Disabled. If you have installed a new add-on and the system reconfiguration has caused a serious conflict resulting in the operating system boot failure, select Enabled to reset Extended System Configuration Data (ESCD) when you exit Setup. The settings are: Enabled and Disabled.

Resource Controlled By

The Award Plug and Play BIOS has the capability to configure all of the boot and Plug and Play compatible devices automatically. However, this capability means absolutely nothing unless you are using a Plug and Play operating system, such as Windows→95/98. If you set this field to “manual”, choose specific resources by going into each of the sub menu that follows this field (a sub menu is preceded by a “>”).

The settings are: Auto(ESCD), Manual.

IRQ Resources

When resources are controlled manually, assign each system interrupt a type, depending on the type of device using the interrupt.

Please refer to section 3-9-1

PCI/VGA Palette Snoop

Leave this field at Disabled. The settings are Enabled, Disabled.

3-9-1 IRQ Resources

CMOS Setup Utility – Copyright(C) 1984-2003 Award Software

IRQ Resources

IRQ3	assigned to	PCI Device	Item Help
IRQ4	assigned to	PCI Device
IRQ5	assigned to	PCI Device
IRQ7	assigned to	PCI Device	Menu Level >>
IRQ9	assigned to	PCI Device
IRQ10	assigned to	PCI Device
IRQ11	assigned to	PCI Device
IRQ12	assigned to	PCI Device
IRQ14	assigned to	PCI Device
IRQ15	assigned to	PCI Device

↑↓→← Move Enter:Select +/-/PU/PD:Value F10:Save ESC:Exit F1:General Help

F5:Previous Values F6:Optimized Defaults F7:Standard Defaults

30