AMD N2PA-LITE Install Memory, Valid Memory Configurations Bank Pin Dimm, Pcs, Total Memory

Overheat Protect: Only for Athlon XP series CPU, when the CPU is overheated, system will automatically shut down power supply. You can hear a continue beep sound, the power button will be locked up. You must turn off and turn on the AC power to reset the system. Otherwise, the power button will not function. The other way is to keep pressing the button for a few seconds till the beep sound stops. Then, release the power button and press the power button again to turn on the power supply.

To install a CPU, first turn off your system and remove its cover. Locate the ZIF socket and open it by first pulling the lever sideways away from the socket and lift the lever upward to a 90-degree angle. Insert the CPU with the correct orientation as shown below. The notched corner should be pointed toward the end of the lever. The CPU has corner pin on two of the four corners and the CPU will only fit in the orientation as shown.

Socket 462

Colden Arrow

CPU ZIF Socket-A

When you insert the CPU onto the ZIF socket, no force is required. After inserting, press the lever slightly without any extra force to lock CPU in position.

2-4 Install Memory

This motherboard provides two 184-pin DUAL INLINE MEMORY MODULES (DIMM) sockets for memory expansion from a minimum memory size of 64MB to maximum memory size of 2.0GB DDR SDRAM.

Valid Memory Configurations

Bank		184-Pin DIMM		PCS	Total Memory
Bank 0, 1	(DIMM1)	DDR 266/333/400	DDR SDRAM	X1	64MB∼1.0GB
Bank 2, 3	(DIMM2)	DDR 266/333/400	DDR SDRAM	X1	64MB∼1.0GB
Total		System Memory (Max. 2.0GB)		2	64MB∼2.0GB

NOTE! Make sure the total installed memory size does not exceeds 2.0GB. Otherwise, the system may hang during startup.

Generally, installing DDR SDRAM modules to the motherboard is very straightforward. Please refer to figure 2-4 for the detail of 184-Pin DDR 266/333/400 DDR SDRAM module and the socket.

9