BASIC OPERATIONS (CONT.)
10. Bank Buttons (19):
These buttons are used to store your cue points and loops. Only a sample or a cue point can be stored into each of these four banks. When a sample is stored in of the banks you may use the sample starting point as a cue point. The BANK BUTTONS (19) instantly recall and play any of your stored cue points or loops. If the unit is not in playback mode, pressing and holding any of the BANK BUTTONS (19) that stores a loop or cue point, will immediately begin to playback from that point until that BANK BUTTON (19) is released.
To store a loop:
1) Create a loop (see creating a seamless loop on page 23 and 24).
Figure 22
Figure 23
2)Press the SAVE BUTTON (20). The SAVE BUTTON (20) LED will glow indicating memory is ready to be stored.
3)Select one of the four BANK BUTTONS (19) you wish to store your loop in and press that button.
4)The SAVE BUTTON (20) LED will turn off, when your cue point or loop is locked into memory.
5)At this point your loop has been stored into memory. The loop you
created will remain playing until the OUT BUTTON (22) is pressed (Figure 24).
6)Your cue point or loop can now be recalled at any time even when the unit is in PAUSE MODE. To recall, press the corresponding BANK BUTTON (19).
Figure 24
©American Audio® - www.AmericanAudio.us - VERSADECK Instruction Manual Page 25
