American Audio Versadeck manual Front & Rear Panel, Front Panel Figure

GENERAL FUNCTIONS AND CONTROLS (Cont.) FRONT & REAR PANEL

Figure 4

37 38 39 40 41 42 43 44

56	54	52	50	47	48	46	Figure 5
55	53	51		46	49	47	45

C. FRONT PANEL (FIGURE 4)

37.MICROPHONE 1 JACK - This jack accepts a standard 1/4 plug. The volume output level for this micro- phone will be controlled by its own respective MIC KNOB (38). Note: We recommend that you use a 500- 600ohm microphone for the best sound quality.

38.MICROPHONE 1 VOLUME - This knob is used to regulate the microphone 1 output volume. Turning the knob in a clockwise direction will increase the volume level.

39.MICROPHONE 2 VOLUME - This knob is used to regulate the microphone 2 output volume. Turning the knob in a clockwise direction will increase the volume level.

40.MIC TONE CONTROL - This knob controls the frequency response of the microphone.

41.TALKOVER CONTROL - This function decreases all signal output except for the microphone signal.

42.CUE MIX - This slider is used to send a channels incoming signal to the headphones. Slide the slider to the left to monitor Channel 1, and to the right to monitor Channel 2. The cue level is adjusted by the CUE LEVEL VOLUME KNOB (43). Be sure the cue level is set to minimum before putting a pair of headphones on.

43.CUE LEVEL VOLUME KNOB - This knob is used to adjusts the headphone volume output level. Turn the knob in a clockwise direction to increase the headphone volume.

44.HEADPHONE JACK - This jack is used to connect your headphones to the mixer allowing you to monitor the cue source. Use headphones only rated at 8 ohms to 32 ohms. Most DJ headphones are rated at 16 ohm, these are highly recommended. Always be sure the CUE LEVEL VOLUME (43) is set to minimum before you put the headphones on.

D. REAR PANEL (FIGURE 5)

45.MICROPHONE 2 JACK - This combo jack will accept a standard 1/4 plug or XLR 3-pin balanced male plug. The volume output level for this microphone will be controlled by the MIC 2 VOLUME CONTROL KNOB (39).

Note: We recommend that you use a 500-600ohm microphone for the best sound quality.

©American Audio® - www.AmericanAudio.us - VERSADECK Instruction Manual Page 15