American Dryer Corp MDG-120PVV Procedure For Functional Check Of Replacement Components, Section

SECTION X

PROCEDURE FOR FUNCTIONAL CHECK

OF REPLACEMENT COMPONENTS

1.Microprocessor Controller (Computer) Board

a. Phase 7 Non-Coin Models

1) Upon completing installation of the replacement microprocessor controller (computer) board, reestablish power to the dryer.

2) Start the drying cycle by pressing any of the preset cycles in letters A-F.

3) Verify that the applicable indicator lights on the microprocessor controller (computer) board are lit. (Refer to the illustration below.)

113395 - 6 Maytag Co. 43