English

450 and 700 VA

Use the computer interface port for unit monitoring and control. See section 7.

The configuration button changes the unit’s sensitivity to utility voltage variations and the low battery warning interval. See sections 5.9 and 5.10.

The configuration LED indicates the voltage sensitivity setting and the low battery warning interval. See sections 5.9 and 5.10.

The site wiring fault indicator comes on when the unit is connected to an improperly wired AC power outlet. See section 4.8.

The output circuit breakers (2200 VA and 3000 VA models only) trip when the connected loads exceed the protected receptacle’s capacity. The center plunger of the circuit breakers extend when tripped.

The input circuit breaker trips when loads exceed the unit’s capacity. The center plunger of the circuit breaker extends when tripped. The paddle handle on 3000VA model input circuit breaker shows“off” when tripped.

Use the transient voltage surge suppression(TVSS) ground connector for the ground leads of telephone or network line protectors. See section 4.9.

The input power connector is a power cord with a NEMA 5-15P connector for 450 through 1400 VA models. See the table below for input power connectors on 2200 VA and 3000 VA models.

The output power receptacles are NEMA 5-15R type. Optional output power receptacle kits are available from the factory for the 2200 VA and 3000 VA models. See your dealer or call the number at the front of this manual for more information.

Optional accessories can be installed in the accessory slot. See section 4.4 and section 7.

Use the battery pack connector to connect the optional external battery pack (3000 VA model only).

7

Page 11
Image 11
American Power Conversion 2200 manual 700 VA