Ampro Corporation 420 quick start Contents

Contents

Chapter 1	Setting Up the CoreModule 420	1
Using this Guide		1
Requirements		1
What’s in the Box		1
Setup Steps		2
Preparations		2
Setting Up the Workspace		2
Connecting Cables to the CoreModule 420		3
Connecting Boot Devices and Peripherals		7
Applying Power to the CoreModule 420		8
Chapter 2	Installing CoreModule 420 Options	11
DiskOnChip (DOC) Installation		11
Tools Required		11
Installing the DiskOnChip (DOC)		11
Removing the DiskOnChip (DOC)		13
CompactFlash Card Installation		14
Tools Required		14
CompactFlash Card Installation Guidelines		14
Installing the CompactFlash Card		14
Removing the CompactFlash Card		16
Installing Software, Drivers, and Utilities		18
Appendix A	Technical Support	21
Contacting Support		21
Getting Updates		21
Appendix B Connector Part Numbers		23
List of Figures
Figure 1-1. CoreModule 420 Connector Locations		3
Figure 1-2.	Module Pin-1 Locations	3
Figure 1-3.	Connecting IDE, Video, and Floppy/Parallel Cables	4
Figure 1-4.	Connecting Floppy-to-Parallel Adapter Cable	5
Figure 1-5.	Connecting Utility, Serial(s), Ethernet, USB, and Power Cables	6
Figure 1-6.	Connecting Battery	6
Figure 2-1.	Installing DiskOnChip	12
Figure 2-2. Removing DiskOnChip		13
Figure 2-3.	Installing the CompactFlash Card	15
Figure 2-4.	CompactFlash Card Installed	16
Figure 2-5. Removing the CompactFlash Card		17
List of Tables
Table 1-1.	Jumper Settings	10
Table 2-1.	DiskOnChip Jumper Settings	12
Table A-1.	Technical Support Contact Information	21
Table B-1.	Connector and Manufacturer’s Part Numbers	23

CoreModule 420 QuickStart Guide iii