Ampro Corporation 420 quick start Skip any steps that do not apply to your situation

Chapter 1 Setting Up the CoreModule 420

Skip any steps that do not apply to your situation.

1) Connect IDE cable

The IDE cable and its adapter are connected to the IDE connector (J6). See Figures 1-1, 1-2, and 1-3.

2)Connect Floppy/Parallel cable

The floppy/parallel cable is connected to the Floppy/Parallel port (J4). See Figures 1-1, 1-2, and 1-3.

3) Connect Floppy-to-Parallel	The Floppy-to-Parallel adapter cable is connected to the cable
adapter cable	connected to the Floppy/Parallel port (J4). See Figures 1-3, and 1-4.

NOTE The Floppy-to-Parallel adapter cable is only required when using the floppy disk drive to access floppy diskettes. To use the parallel port for printer output, disconnect the Floppy-to-Parallel adapter cable and connect directly to the printer’s cable.

4) Connect Video cable (CRT) The video cable (CRT) is connected to the Video connector (J11).

See Figures 1-1, 1-2, and 1-3.

		Pin Adapter
Video	IDE Connector	(2mm to .1 inch)
Connector

(Shown with only

one connector for

simplicity)

Pin 1

Floppy/Parallel Port

Connector

CM420QkS_08a

Figure 1-3. Connecting IDE, Video, and Floppy/Parallel Cables

4 QuickStart Guide CoreModule 420