Using The Web Interface

Using The Web Interface

Addressing The Dimmers via The Web Interface

Once you have installed the ALD-H48 and dimmers using the hardware installation literature included with the unit, you must now address the dimmers.

You can only select addresses available on the bus to which the dimmer is physically connected. For example, if you want to assign address 17 to a particular dimmer, it must be connected to bus 3 of the ALD-H48 as indicated below.

Bus Address Location

Bus

Address

11-8

29-16

317-24

425-32

533-40

641-48

To address the dimmers:

1.Using your web browser, go to the target NetLinx Master’s web page.

Refer to the NetLinx Master documentation for more detailed information concerning the NetLinx Master Web Interface.

2.Click on Lights and all connected modules are displayed below Lights. There is only one module per device.

Upon your first visit to Lights, the page will have the following message, FIG. 2.

FIG. 2 Initial Lights Configuration Page

3.Click Address Mode to set the master to look for available dimmers.

4.Tap the dimmer you wish to address three times to make it available to the master.

5.The displayed addresses are only those that are available on that physical bus that have not been used. Bold text indicates the address has already been assigned. Pick an available number and click Select to address the dimmer.

ALD-H48 Lighting Controller

5

 

 

 

 

Page 11
Image 11
AMX ALD-H48 instruction manual Using The Web Interface, Addressing The Dimmers via The Web Interface