Using The Touch Panel Pages

Addressing Dimmers

1.From the Main page, push the Setup button.

2.Push the Addressing Off button, this will place the ALD-H48 in addressing mode.

3.Push the dimmer you wish to address three times. The serial number of the dimmer appears at the bottom of the page as a confirmation.

4.Select the address number for the dimmer. Remember to select the bus to which the dimmer is physically attached. It is recommended you assign unique names to the address buttons after you have addressed them.

5.Upon a succesful addressing of a dimmer, a confirmation message is displayed at the bottom of the page and Addressing mode is turned off automatically Otherwise, an error message is displayed.

If you select the wrong bus the addressing fails to assign.

Setting Unique Names

1.Press the dimmer address button for three seconds.

2.Type the name you wish to assign to the button.

3.Press Done to save and exit.

Groups Page

The Groups page allows you to set and edit dimmers into groupings of several dimmers. Represented on the page is 48 buttons for each possible dimmer, grouped according to corresponding buses. The buttons are either numbered, or custom labels if assigned.

 

14

ALD-H48 Lighting Controller

 

 

 

Page 20
Image 20
AMX ALD-H48 instruction manual Groups, Addressing Dimmers