AMX ALD-H48 instruction manual ?Version

Advanced Programming

Command Interface (Cont.)

Command Description

*SETSCENE-<sceneNmbr>,Sets a scene. Adds (appends) a dimmer to the scene. You may add

<Addr/index>,	each dimmer as a separate item in the scene or add up to and
<level>,	including 10 dimmers as the same item in the scene.
<FadeTime>,	If several dimmer addresses are added as the same item in the
<DelayTime>	scene, their addresses must be separated by a semicolon (;).By
	adding each dimmer as a separate item in the scene, when the scene
	is recalled, it will execute each item sequentially. This is beneficial
	because it can execute a large number of commands (similar to a
	macro) with different <level>, <FadeTime>, and <DelayTime> values,
	however, the commands are not executed simultaneously. By adding
	up to 10 dimmers as the same item in the scene, when the scene is
	recalled, it will change the settings of the dimmers simultaneously. A
	drawback is the limited number of dimmers that can be added this
	way (up to 10) and the fact that the same <level>, <FadeTime>, and
	<DelayTime> will be used for all of them.
	<sceneNmbr>: 1..48 = scene number to set
	<Addr/index>: Dimmer Address(es) or lighting
	component Index to add to
	scene.
	<level>: 0..255 = light level to go to.
	<FadeTime>: 0..n = time, in seconds, to reach
		desired level.
	<DelayTime>: 0..n= time, in seconds, to delay
		execution.
	Example:
	SETSCENE-1,2,230,5,1	(add component index 2 to scene 1)
	SETSCENE-1,[1:4:1:1:1],200,3,2 (add a separate dimmer item)
	SETSCENE-1,[1:4:1:2:1];[1:4:1:2:2],156,0,0
?VERSION	Query for the module version.
	Responds with VERSION-<version>
	Example:
	?VERSION

ALD-H48 Lighting Controller 29