AMX Anterus ANT-BDG Product Specifications, ANT-BDG Mounting/Installation, ANT-BDG Specifications

Anterus™ RFID Solution

ANT-BDG Product Specifications

ANT-BDG Specifications

RF Specifications:	• Tx Frequency: 433 Mhz
	• Field strength: < 1600 µV/m
	• Modulation: ASK
	• Stability: Saw Stabilized

Electrical Specifications: • Power: Internally powered Lithium Battery (non-replaceable)

	• Battery Life span: approximately 5 years.
	Note: All of the Anterus RFID tags run on non-replaceable batteries, which
	provide approximately five years of normal use. Additional and replacement tags
	are available from AMX. Contact your customer service representative for details.
Environmental:	• Operational temperature: 32º F to 140º F (0º C to 60º C)
	• Storage temperature: -4º F to 158º F (-20º C to 70º C)
	• Humidity: 5% to 90% (non condensing)
Enclosure:	• ABS (ultrasonically sealed) IP 65
	• Black
Dimensions (HWD):	3.38" x 2.12" x .19" (86 mm x 54 mm x 5mm)
Weight:	0.8 oz. (22.68 grams)
Certifications:	This device complies with Part 15 of the FCC Rules. Operation is subject to the
	following two conditions:
	• This device may not cause harmful interference, and,
	• This device must accept any interference received, including interference that
	may cause undesired operation.
	The following standards applied in accordance with Article 5 of the directive, 1999/
	5/EC:
	• EN 300 220-1 V1.2.1 (1997-11)
	• ETS 300 683 (1997-03)
	Any modification of this device without the express consent of the manufacturer
	could void the user authority to operate the equipment.

ANT-BDG Mounting/Installation

ANT-BDG Tags can be mounted on a variety of items. Where permanent fixing is required VHB double- sided tape is used (Product number L-TA200); otherwise, the tags may be worn on a necklace or clipped to clothing.

If you will be fixing personnel photos to the ANT-BDG, use a Badge/Slot Punch capable of a throat reach of 1/4” (FIG. 7).

Depth =.25” (6.35mm)

Punch-out height =

.25” (6.35mm)

Punch-out width = 1.625” (41.27mm)

FIG. 7 ANT-BDG - Slot Punch dimensions

ANT-BDG Antenna Orientation

ANT-BDG ID Badge tags are typically worn on a necklace or clipped to clothing, which typically results in a vertical antenna orientation. There is a horizontal orientation for the ANT-BDG Tags, but it is typically reserved for installations that use the ANT-BDG Tags as windshield-mounted vehicle tags.

Anterus RFID Solution 7