Communication and Firmware Update
Assigning a Static IP to the NetLinx Master
1.Select Diagnostics > Network Addresses from the Main menu.
2.Verify the System number corresponds to the value previously assigned in the Device Addressing tab for the specific System Master.
3.Verify that zero (0) is entered into the Device field.
The system value must correspond to the Device Address previously entered in the Device Addressing tab. Refer to the Setting the System Value section on page 21 for more detailed instructions on setting a system value.
4.Verify that NetLinx appears in the Host Name field.
5.Click the Specify IP Address radio button from the IP Address section (FIG. 21).
System Address reflects the value set in the Device Addressing tab
Used to assign an
IP Address
FIG. 21 Network Addresses dialog (showing Set IP)
6.Enter the IP Address, Subnet Mask, and Gateway information into their respective fields.
7.Click the Set IP Information button to retain a known IP Address (obtained from the System Administrator) on the specified System Master.
8.Click OK to accept the new changes.
9.Click the Reboot Master button and select Yes to close the Network Address dialog. This process closes the Network Addresses dialog and directs you to the Reboot the Master Controller dialog.
10.Click Continue (from the Reboot controller dialog) and wait for the System Master to reboot and incorporate the newly obtained DHCP Address. The STATUS and OUTPUT LEDs should begin to alternately blink during the incorporation. Wait until the STATUS LED is the only LED to blink.
11.
Verify that these IP values are also entered into the related fields within either the IP Settings section of the System Connection page (on the touch panel) or within the Address field on the web browser.
27 |
| |
|
|
|
