AMX NXC-ME260 Specifications Cont, Rear panel LEDs ICSNet/ICSHub, Rear panel LEDs Ethernet

Product Information

NXC-ME260 Specifications (Cont.)

Rear Panel Components
(Cont:)
AXlink connector	4-pin (male) black captive-wire connector provides data and power to external
	control devices.
	• Power rating = 6 A max; actual load depends on connected power supply.
Axlink Status LED	Green LED lights to show AXlink and expansion port data activity.
Program port	5-pin (male) grey connector for system programming and diagnostics. There is
	a Program port located on the front and rear of the Master Cards for easy
	access. Because these ports share the same circuitry, you should never use
	both ports at the same time. Doing so will result in communication and/or
	programming errors.
ICSNet connectors	Two RJ-45 connectors that provide power (500 mA) and data to external
	ICSNet devices.
ICSNet LEDs	Green LEDs that light when receiving data on that port.
ICSHub In/Out connectors	Two RJ-45 connectors that provide data to other Hubs connected to the
	Master.
ICSHub IN/OUT LEDs	Yellow LEDs that light when receiving data on that port.
Included Accessories:	• Connector Bag containing:
	- One Green 2-pin 3.5 mm mini-Phoenix connector (female) (41-5025)
	- One Black 4-pin 3.5 mm mini-Phoenix connector (female) (41-5047)
	- One Grey 5-pin 3.5 mm mini-Phoenix connector (female) (41-5053)
	- One back panel (51-2010-61)
Optional Accessories:	• AC-RK Accessory Rack Kit (FG515)
	• PSN2.8: Power Supply (FG423-17) with 3.5 mm mini-Phoenix connector
	• PSN4.4: Power Supply (FG423-45) with 3.5 mm mini-Phoenix connector
	• PSN6.5: Power Supply (FG423-41) with 3.5 mm mini-Phoenix connector

Rear panel LEDs: ICSNet/ICSHub

ICSNet LED (green)		IN
lights to indicate data
input activity on this port		OUT
	ICSNet	ICSHub

FIG. 2 Layouts of the ICSNet and ICSHub LEDs

ICSHub IN LED (yellow) lights to indicate data input activity on this port

ICSHub OUT LED (yellow) lights to indicate data input activity on this port

Rear panel LEDs: Ethernet

A - Activity LED (yellow) lights when receiving Ethernet data packets

SPEED LED (green) lights when transmitting data at 100 Mbps, and is Off when transmitting at 10 Mbps

FIG. 3 Layout of Ethernet LEDs

ETHERNET

10/100

SPEED FD

L - Link LED (green) lights when the Ethernet cables are connected and terminated correctly

FD - Full Duplex LED (green) lights when running in full duplex mode, and is Off when running in half duplex mode

NXC-ME260 NetLinx Master-Ethernet Card/Module 3