Remote Control
Continued
PREPARING THE REMOTE CONTROL
To operate the DVD video player, you must first place the batteries into the remote control.
1 |
| 2 |
| 3 |
Open the battery cover. | Insert two batteries (AAA size). | Close the battery cover. |
| Make sure to match the + and - on the |
|
| batteries to the marks inside the battery |
|
| compartment. |
|
OPERATING WITH THE REMOTE CONTROL
Operating DVD video player with the remote control.
1
The remote control must point at the remote sensor, in order for the DVD player to function correctly. Make sure there is no barrier between them.
Distance: Maximum of 5 m from the front of the remote sensor.
Angle: Approximately 30º from each direction.
*Please do not place the remote sensor towards any light source such as direct sunlight or illumination. The DVD video player will malfunction, if you do so.
NOTICE (BATTERIES)
FOLLOW INSTRUCTIONS BELOW BECAUSE INCORRECT USE OF BATTERIES MIGHT CAUSE THEM TO LEAK OR CORRODE.
•Do not place the batteries in the wrong direction.
•It is dangerous to charge/heat/open or
•Do not leave dead batteries or mix old/new batteries in the remote control.
•When not using the remote control for a long duration of time, remove the batteries.
•When difficulties occur, with the remote control, or if the operating range becomes reduced, then replace the batteries.
•If leakage from the battery occurs, wipe the battery liquid from the battery compartment, then replace the batteries.
•With normal usage the batteries should last one year.
NOTICE (REMOTE CONTROL)
•The remote control should be aimed directly towards the remote sensor of the DVD video player.
•Avoid dropping the remote control.
•Avoid spilling any liquids and/or extreme heat.
A P E X | D I G I T A L | 9 |
