Troubleshooting | Checking High Voltage - 15 | |
|
|
|
Before you begin, remove:
•Rear Housing
•EMI Shield
1 Attach the Apple
2 Be sure the monitor is attached to a computer and has power. 3 Turn on the monitor.
4 Carefully insert the probe under the anode wire connector.
5 The reading should be 25 VDC on the meter. This is actually 25 kV. Most of the voltage is across the
Warning: Do not remove the probe from under the anode wire connector until power is turned off. Injury or damage to equipment may
occur.
6Turn off monitor.
7Unplug monitor.
8Remove the probe from under the anode wire connector.
9Go to the “No Raster Flowchart.”
