Apple CPX3 manual Image Menu, Over Scan, Position

IMAGE Menu

IMAGE Menu

From the IMAGE menu, items shown in the table below can be performed.

Select an item using the ▲/▼ cursor buttons, and press the ► cursor button or ENTER button to execute the item. Then perform it according to the following table.

Item	Description
	Using the ▲/▼ buttons switches the mode for aspect ratio.
	For a PC signal
	NORMAL ó 4:3 ó 16:9 ó 16:10 ó REAL
	For an HDMI signal
	NORMAL ó 4:3 ó 16:9 ó 16:10 ó 14:9 ó REAL
ASPECT	For a Video signal, s-video signal or component video signal
	4:3 ó 16:9 ó 16:10 ó 14:9 ó REAL

For no signal

16:10 (fixed)

•This item can be selected only for a proper signal.

•The NORMAL mode keeps the original aspect ratio setting.

•Performing the automatic adjustment initializes the aspect ratio setting.

	Using the ▲/▼ buttons adjusts the over-scan ratio.
OVER SCAN	Large (It reduces picture) ó Small (It magnifies picture)
	• This item can be selected only for a video, s-video and component video signal.
	• When this adjustment is too large, certain degradation may appear
	at the frame area of the picture. In such a case, please adjust small.
	Using the ▲/▼ buttons adjusts the vertical position.
	Up ó Down
	• Over-adjusting the vertical position may cause noise to appear on the
	screen. If this occurs please reset the vertical position to the default setting.
V POSITION	Pressing the RESET button when the V POSITION is selected will reset the
	V POSITION to the default setting.
	• When this function is performed on a video signal, s-video signal, or
	component video signal, the range of this adjustment depends on the
	OVER SCAN (above) setting. It is not possible to adjust when the OVER
	SCAN is set to 10.
	Using the ▲/▼ buttons adjusts the horizontal position.
	Left ó Right
	• Over-adjusting the horizontal position may cause noise to appear on the
	screen. If this occurs please reset the horizontal position to the default
H POSITION	setting. Pressing the RESET button when the H POSITION is selected will
	reset the H POSITION to the default setting.
	• When this function is performed on a video signal, s-video signal, or
	component video signal, the range of this adjustment depends on the
	OVER SCAN (above) setting. It is not possible to adjust when the OVER
	SCAN is set to 10.

26(continued on next page)