Troubleshooting

Phenomena that may be easy to be mistaken for machine defects

About the phenomenon confused with a machine defect, check and cope with it according to the following table.

Phenomenon

Cases not involving a machine defect

Reference

page

 

 

 

 

 

 

The electrical power cord is not plugged in.

10

 

Correctly connect the power cord.

 

 

 

The main power source has been interrupted during

 

 

operation such as by a power outage (blackout), etc.

10, 13

 

Please disconnect the power plug from the power outlet,

Power does not

and allow the projector to cool down at least 10 minutes,

 

then turn the power on again.

 

come on.

 

 

Either there is no lamp and/or lamp cover, or either

 

 

 

 

of these has not been properly fixed.

 

 

Please turn the power off and disconnect the power plug from

52

 

the power outlet, and allow the projector to cool down at least

 

45 minutes. After the projector has sufficiently cooled down,

 

 

please make confirmation of the attachment state of the lamp

 

 

and lamp cover, and then turn the power on again.

 

 

The signal cables are not correctly connected.

8

 

Correctly connect the connection cables.

 

 

 

Signal source does not correctly work.

 

Correctly set up the signal source device by referring to the

Neither sounds

manual of the source device.

 

The input changeover settings are mismatched.

 

nor pictures are

14, 15

outputted.

Select the input signal, and correct the settings.

 

 

The BLANK function for pictures and the MUTE

 

 

function for sounds are working.

40

 

AV Mute may be active. Refer to the item “Sound does not

 

come out” and “No pictures are displayed” on the next page

 

 

to turn off the MUTE and BLANK functions.

 

 

The signal cables are not correctly connected.

8

 

Correctly connect the audio cables.

 

 

 

The MUTE function is working.

14

 

Restore the sound pressing the MUTE or VOLUME button

Sound does not

on the remote control.

 

come out.

The volume is adjusted to an extremely low level.

14

 

Adjust the volume to a higher level using the menu function

 

or the remote control.

 

 

The AUDIO setting is not correct.

32

 

Correctly set the AUDIO in the SETUP menu.

 

 

 

The lens cover is attached.

13

No pictures are

Remove the lens cover.

 

displayed.

The signal cables are not correctly connected.

8

 

Correctly connect the connection cables.

 

 

(continued on next page)

59

Page 59
Image 59
Apple CPX3 Electrical power cord is not plugged, These has not been properly fixed, Signal source does not correctly work