1)Locate the switch block on the controller card.

2)If a piece of tape is covering the switches, remove it.

3)Set the switches in the position shown below.

Switch Setting

1OPEN

2CLOSED

3CLOSED

4CLOSED

Switches Set for Pseudo-SlottIng

8 ) Insert Card Into Slot

Align the gold “fingers” of the controller cards edge connector with the slot; then use the heel of one hand to push the card down into the slot and seat it firmly.

Insert Controller Card into Slot

9 ) Connect Cable from power Drive to Controller Card

Attach the wide flat cable from the hard drive to the connector on the controller card. The connector and socket are keyed so that they will attach in only one way.

Make sure that the cable connector is firmly seated in the controller card socket.

Ch. 1 - IIGS Installation

5