15 Main Unit Operation
SET
POINTER
Display the pointer.
Press the SET/POINTER button to display the pointer. Press it again to hide the pointer.
Press the SCROLL button to move the pointer.
Remote Control Operation
POINTER/
SET
NOTE
Adjusting the zoom or the brightness while the pointer is displayed may cause it to disappear momentarily, but it will reappear after a short time.
16 Remote Control Operation
POINTER TYPE
Select the type of pointer.
You can switch the type of pointer with the POINTER TYPE button on the remote controller. (Select from 
, 
, or 
.) You can also select the type from “Pointer type” on the “Setting 2” menu. See page
17 Main Unit Operation
MUTE
Remote Control Operation
MUTE
NOTE
Mute the image.
Press the MUTE button to stop projecting the image without turning off the lamp. You can select the image projected while the image is muted from the following two images.
qProject a completely black image while the projected image is muted.
Set “Black” in “Mute mode” on the “Setting 2” menu (page
image 
icon is displayed on the top right side of the projected image.
wProject an arbitrary image while the projected image is muted. Set “logo” in “Mute mode” on the “Setting 2” menu (page E-
45).
While the image is muted, the projecting image 
icon is displayed on the top right side of the screen.
After the projected image has been muted for a certain amount of time (about 15 minutes) it automatically goes into standby.