ADDENDA: LOW NOX HEATERS (CONTINUED)
Fig # 9362
LOW NOx BURNER TRAY ASSEMBLY
BURNER DRAWER REMOVAL
1.Shut off main electrical power switch to heater.
2.Shut off gas upstream of heater.
3.Remove front door.
4.Disconnect gas line from gas valve.
5.Remove (2) screws that mount burner tray to the base of the unit, and (2) screws that secure gas valve to jacket.
6.Disconnect wires that terminate at gas valve.
7.Unscrew (4) screws that secure the control box.
8.Disconnect pilot wire from the ignition module.
9.Disconnect wire harness from the combustion blower.
10.Carefully slide out the burner tray assembly.
11.Reverse above procedure to reinstall.
GAS VALVE REMOVAL
1.Remove burner drawer. See burner removal procedure.
2.Disconnect, pilot tubing from gas valve.
3.Turn vertical gas pipe from manifold slightly and unscrew gas valve.
4.Reverse above procedure to
MAIN BURNER AND ORIFICE REMOVAL
1.Remove burner drawer. See burner drawer removal procedure.
2.Remove pilot. See pilot removal procedure.
3.Remove (8) total screws from the hold down brack- ets, front and rear of tray.
4.Remove (8) total screws from the left and right sides of the Manifold assembly. Detach the manifold as- sembly from the burner tray assembly.
5.Remove burners by raising the bracket on the back end of the burners up and out of their slots.
6.Use a long 9/16” socket wrench to remove orifices from the gas manifold.
7.Reverse above procedure to
Fig # 9363
IIDPILOT
PILOT REMOVAL
1.Disconnect pilot tubing from gas valve.
2.Remove (4) screws from control box. Open the control box.
3.Remove the pilot wire from the ignition wire.
4.Remove (2) screws that mount the pilot bracket to the air manifold assembly.
5.Pull the pilot bracket slightly, then drop and pull downwards and outwards.
6.Reverse above procedure to
Fig# 9368
COMBUSTION FAN REMOVAL
1.Remove burner drawer. See burner drawer removal procedure.
2.Remove (4) screws the mount the combustion blower to the manifold assembly.
3.Reverse above procedure to
31