Ask Proxima 9100 manual Turning On The Projector

TURNING ON THE PROJECTOR

The projector and the external monitor (if you’re using one) should be turned on before you turn on your computer. This ensures that the computer properly senses the display during it’s start-up process.

On the rear panel of the projector there is a power cord receptacle and a power switch.

Figure 1-9, The power switch

To turn on the projector:

1Plug the power cord into the projector’s power receptacle.

2Plug the other end of the power cord into a properly grounded electrical outlet.

3Move the POWER switch to the ON position.

4Press the key to turn on the lamp. The lamp will ignite slowly.

5If you haven't already done so, connect the projector to your computer and external monitor (if you're using one).

6Turn on your computer and external monitor (if you’re using one).

You should see a projected image of your computer screen. You’ll see how to focus the image shortly.

Note: The DP9100 consumes 800 watts of power. Most circuits and surge protectors support 1200 watts. Make sure to connect any peripheral equipment to a separate circuit or surge protector.

1-6Chapter One