Ask Proxima 9100 manual Connecting video from S-Video sources, Connecting audio from the computer

The Composite Audio/Video cable (C497-6) has a yellow, red, and white RCA plug at each end. To connect an NTSC, PAL, or SECAM source to your projector:

CABLE	PROJECTOR PORT		VCR CONNECTOR
(C497-6)
Yellow	VIDEO 1 or 2.		Video Out, To Monitor, etc.
White	AUDIO 1 or 2	IN (white plug).	Left Audio Out.
Red	AUDIO 1 or 2	IN (red plug).	Right Audio Out.

Connecting video from S-Video sources

The Desktop Projector 9100 can also project video from an S-Video source.

1Connect one end of the S-Video cable (C466-6) to the Video Out connector on the video source. The cable has identical round four-pin connectors on either end.

2Connect the other end of the cable to the projector’s S-VIDEO 1 port.

Connecting audio from the computer

Use the COMPUTER AUDIO IN port to connect audio from a computer.

1Insert the mini jack end of the computer audio cable (C498-6) into the AUDIO OUT connector of a Macintosh or the sound card of a PC.

2Insert the RCA jacks at the other end of the computer audio cable into the projector’s left and right COMPUTER AUDIO IN ports.

Computer

Audio In

A

Figure 1-23, Connecting audio from the computer

Connecting a microphone

To use a microphone while projecting an NTSC, PAL, SECAM, S-Video, or computer image, plug an amplified or wireless microphone equipped with a line level output (maximum 1 volt, peak-to-peak) into the MIC port.

1-18Chapter One