Ask Proxima 9100 manual Half-Normal Height Display

Half-Normal Height Display

Figure 6-3, Adjusting the half-normal height display

Use the arrow keys, the Setup key on the control panel, or use the following procedure to adjust the half-normal height display:

1Press the Menu key. The Main menu displays.

2Select Advanced from the Main menu.

3Select the Hor. Pos (Horizontal Position) slide bar.

4Press the down arrow key until the is properly aligned. (If this adjustment does not correct the problem, reset the Hor. Pos control.)

Note: There are separate Hor. Pos and Vert. Pos values for Normal and Fit-to-View Modes. Adjustments in one mode are not made in the other.

5Press the right arrow key to select the Vert. Pos (Vertical Position) slide bar.

6Press the down arrow key until the image displays properly.

(If this adjustment does not correct the problem, reset the Hor. Pos control to the default.)

If neither parameter corrects the problem, you must find the correct Dot Clock value to prevent image distortion. Make changes to this parameter SLOWLY to avoid skipping over the desired value. Considerable trial and error may be required.

7Select Image on the Main Menu.

8Select the Dot Clock slide bar with the right arrow.

9Move the slide bar up or down until the image displays properly.

If none of these adjustments corrects the problem, try a different SOURCE MODE selection. Make sure the selection has the correct resolution and the closest V-sync and H-sync values.

6-6Chapter Six