ASRock WiFi Motherboard K10N780SLIX3 Onboard Headers and Connectors, Primary IDE connector Blue

2.8 Onboard Headers and Connectors

Onboard headers and connectors are NOT jumpers. Do NOT place jumper caps over these headers and connectors. Placing jumper caps over the headers and connectors will cause permanent dam- age of the motherboard!

•

Floppy Connector

(33-pin FLOPPY1)

(see p.2, No. 28)

the red-striped side to

Pin1

Note: Make sure the red-striped side of the cable is plugged into Pin1 side of the connector.

Primary IDE connector (Blue)

(39-pin IDE1, see p.2, No. 9)

connect the blue end	connect the black end
to the motherboard	to the IDE devices

80-conductor ATA 66/100/133 cable

Note: Please refer to the instruction of your IDE device vendor for the details.

Serial ATA II Connectors

(SATAII_1 (PORT0):
see	p.2, No. 23)	SATAII_1	SATAII_3	SATAII_5
(SATAII_2 (PORT1):		(PORT0)	(PORT2)	(PORT4)
see	p.2, No. 20)
(SATAII_3 (PORT2):
see	p.2, No. 14)	SATAII_2	SATAII_4	SATAII_6
(SATAII_4 (PORT3):		(PORT1)	(PORT3)	(PORT5)
see	p.2, No. 18)
(SATAII_5 (PORT4):
see	p.2, No. 15)
(SATAII_6 (PORT5):
see	p.2, No. 16)

These six Serial ATAII (SATAII) connectors support SATA data cables for internal storage devices. The current SATAII interface allows up to 3.0 Gb/s data transfer rate.

English

SATAII_6 (PORT5) connector can be used for internal storage device or be connected to eSATAII connector to support eSATAII device. Please read “eSATAII Interface Introduction” on page 30 for details about eSATAII and eSATAII installation procedures.

2 5

ASRock K10N780SLIX3-WiFiMotherboard